Restoring the Heathkit Jr 35

Heathkit Jr Electronic Workshop "35", Model JK-18

The Heathkit Jr 35 evidently had been stored with batteries in the battery holder, which corroded badly. I replaced it with a plastic RadioShack 4 D-cell battery holder (270-389), wired into the negative power rail and the hot side of the power switch (which is part of the variable resistor).
Corroded battery holder
Replacement battery holder mounted
I mounted the replacement battery holder with a dozen "heavy duty" 1 inch foam double-stick mounting squares (rated to hold 900g), stacked in four groups each three high to overcome the various screws protruding through the main board.
The remote speaker station

The rubber foot used to protect the relay from being crushed when you turn the kit over was stuck to the remote speaker station. I put it in its rightful place.
Relay with the brown rubber foot
Earlier, I had built a couple simple circuits, which showed the meter and new battery pack working, but showed me the telegraph key switches were not making good contact. I used a Scotch-Brite scrubbing pad to remove corrosion from the key switches on the main board and the remote station.

I ran through the tests in the manual appendix to check out the lamp, power switch, speaker, earphone, antenna coil continuity, remote station speaker & telegraph key, slide switch, and relay.

I then jumped ahead of myself, building the 4-transistor AM radio experiment; I got slight hints of a audio signal if I wiggled and touched some of the wires. I'm highly suspicous of the electrolytic capacitors. I probably should have tested those (and the transistors) before using them in such a complex circuit. The wire connections to the springs are not all that reliable, and the wires might have some oxidation on them.

Comments

  1. Thanks for posting these photos! This was one of my favorite things back when I was a kid. Very educational, and better than any educational electronics "labs" kids can get in the last twenty years. As a 3D artist, I've been making 3D models of some of the toys and things I had from ages 0 to, well, no upper bound. This Electronics Workshop was very hard to find any info about or photos. These are excellent photos. I don't know about for the cover of Architectural Digest :P but great as art reference. May you live long in health and happiness, and have more than four transistors for your next project!

    ReplyDelete
  2. Wow, that is antique— back when those cylindrical carbon resistors were still used, before LEDs were an affordable reality (incandescent lamp used here). Copper springs? These Heathkit Jr. models date back to the late 1960s.

    Contrast this to the newer, unrelated 100-300 piece kit models with LEDs (almost never lamps) you would've found at RadioShack. And I say ‘would've,’ because they've changed their business model, going for cell phones and the like instead of components.

    Old electrolytic capacitors, like batteries gradually lose their charging abilities and may leak (every reason to be “highly suspicous”). Then again, I’ve seen the innards, sometimes looking like cake, having blown out the top of one by introducing it to too much voltage.

    ReplyDelete
  3. who's here from waitbutwhy lol

    ReplyDelete
  4. I've had my Heathkit Workshop 35 for more than forty years now. It was a Christmas gift from mom&dad. I looked at it today, first time in a long time, its much older looking than yours, dusty, broken relay, missing transistor. I sure had a lot of fun with it.

    ReplyDelete
  5. Don't have mine anymore but it gave me a direction in life. Have worked with electronics since. I am missing page 1-58 in my manual. Any help would be appreciated.

    ReplyDelete
  6. Don't have mine anymore but it gave me a direction in life. Have worked with electronics since. I am missing page 1-58 in my manual. Any help would be appreciated.

    ReplyDelete
  7. Don't have mine anymore but it gave me a direction in life. Have worked with electronics since. I am missing page 1-58 in my manual. Any help would be appreciated.

    ReplyDelete
  8. I had one of these as a kid and it was my introduction into electronics. I loved it. I found one on eBay that I'm reconditioning for my grandson who is electronics minded. However, it did not come with a manual. Would anyone who has a manual be willing to take photos of the experiments pages and share them with me? I would be most grateful.

    ReplyDelete
  9. This comment has been removed by the author.

    ReplyDelete
    Replies
    1. I definitely had a similar heathkit as a kid (1974?) with 3-transistors not 4-transistors (probably a Jr-25 set, before this one was released). Mine had a white protoboard, not a red one. I remember the ferrite core antenna and morse code device and 3 transistors because there were radio projects using 1, 2, and 3 transistors, and about 40 projects in all.

      I would love to find a scan of the manual. When I read the "theory of operation" for the transistors, it showed a circular platform with 3 spires holding it up (the transistor leads) and on top of the circular platform was a spherical guy holding open a door or shutting the door for a stream of other little spherical guys running through. My reaction: WTF is this? I don't believe this! Maybe it's why I ended up being a software engineer, not an electrical engineer.

      Delete
    2. http://heathkitcatalogs.com/images/flippingbook/1969/Heathkit_1969_Page_023.jpg

      Delete

Post a Comment

Popular posts from this blog

Open Genera VLM on Linux

FPGA selection for beginners